(Aug. 17, 2019 10:42 PM)Bladerbill Wrote: (Aug. 17, 2019 8:18 PM)azrulryne Wrote: Try lord spriggan.around.octa or lord spriggan.blitz.atomic
Okay, will do
This'll be quite long, but take my opinion with a grain of salt (as all statements below are from testing the combos against current meta alone, not taking into account human opponent launch style/strength/stratagem):
It is good to take note that painted 0 Disks as well as Blitz do fit tightly with LS, and that those tiny Burst resistance increasing nubs on either inner sides of the Layer make it REALLY hard to Burst (and would probably last longer than the Burst resistor gimmick on Judgment Base)
Around is quite iffy and Octa will provide the heaviness but not the LAD potential needed by the combo, so you'd be better off with Around/Blitz/Ratchet/Outer/0/00Wall/Lift/Turn/Bump on Bearing (aka the spin equalizer monster setup)
If you really want to use Atomic, 0/10/00Cross/Glaive/Proof is your best choice on it since Blitz still has a scrape issue only alleviated when used on Bearing and probably an awakened (aka worn out) Volcanic' (which I never had the patience to wear down legally to test reliability)
On Xt+, it'll probably be Outer/0/10/00Cross/Glaive/Proof that can work
For Ds' or Jl' it can be Hurricane/Sting/Blitz/0/10/00Cross/Glaive/Proof/Dagger/Turn/Bump/Expand, depending on your intention of spin equalizing vs pure same spin attacker with a bit of LAD potential
It's also good if you have awareness of how heavy and worn-out are each part you have above before continuing, since repeated assembly-disassembly-assembly-disassembly will probably eventually wear down the following areas of the parts unnecessarily as follows:
1. Spriggan Chip teeth - cuz fitting a Dash Driver variant will definitely put stress on those puppies; very tall teeth so it may be more susceptible to breakage
2. Driver teeth - this goes more for Drivers known for good spring strength and tightness along with the Dash variants
3. Lord Base Burst resistors - those little plastic nubs aid in the Burst resistance aspect, so them wearing down from overdoing assembly-disassembly may be problematic (unless you're not going to use it for tournaments and just for casual or testing alone) especially when going against a player with a fresh copy.
Lastly, since Lord's main contact points are rubber, expect that with continued use you'll eventually have to buy a fresh copy for better performance. If it does wear down tho, I think it may still work as a closer GT remake of Spriggan Requiem, but I'm just speculating.
Ore wa tsuyoi da
IG: @kinghadoukenbeypla
(I try to post daily for things like Beyblade and Gunpla)
if both of them are worn down, and the big gaps in the bottom piece of the B
