Wow, that's quite an unusual break :o Closest I've had was on a sonokong gold driger s ar, the 3 of the 4 parts that poke up to prevent the smaller bit chips slipping out snapped off mid battle. I still haven't found the bitchip that went flying as a result.

A chunk of it that large snapping off isn't something I've seen before, and I've owned a lot of fake beys, so I've seen a few odd snaps :\

My first Hasbro Driger S broke in almost exactly the same place, actually.

---

Some manner of Octopus.

This break didn't happen to me, it happend to...Lets say an aquataince. He was using a fresh out of package Flame Saggitario 145CS, and about two minutes later he stoped just staring at it, ( Retarded, I know. ) he started launching it from as high as hard as he could launch the beyblade, STRAIGHT TOWARD THE GROUND!!! two launches later it broke,me and my friends try and tell total n00bs ( like him. ) not to do that. My breaks are uasually the face bolts of almost any Hasbro model, so I have a lot of un-needed parts. looooong story, isn't it?

Many of us during the Plastics generation did really dumb things with our Beyblades that we saw in the anime - things such as launching at walls, launching on concrete surfaces, etc.

---

Some manner of Octopus.

One time this guy was selling a Driger S (Hasbro).I got it for like 2 bucks and I wondered why.I launched it into the stadium and it was fine.But every battle after that something else was wrong with it until eventually one battle it just fell apart completely.I put the parts in a container and buried in in the front of my house. I think I might dig it up and fix it.If its still there.

---

"Welcome to the end of your life, and I promise its going to hurt!"
-Vegeta
Thanks !Night for the Sig its great!

@ hazel: and bladed on everything, woks, chairs, concrete, bricks, grass, ice, hasbro stadiums and all manner of other bad, beydeath inducing surfaces.

And the amount of easily broken fakes everyone had (real beys were sold out everywhere, fakes cost literally $2, and looked good (some were extemely well moulded) only exacerbated things, as did the oversized "sunfire" wd's, and even the heavy fake gyro wd's I have didn't help matters, especially tip wear.

And that's just the unintentional stuff...

---

th!nkBlargh|H-Code Product List

One time this guy was selling a Driger S (Hasbro).I got it for like 2 bucks and I wondered why.I launched it into the stadium and it was fine.But every battle after that something else was wrong with it until eventually one battle it just fell apart completely.I put the parts in a container and buried in in the front of my house. I think I might dig it up and fix it.If its still there.

Did you give it a coffin, or just buried it?

---

Extras. (Click to View)

Wierdest thing I have ever posted. (Click to View)

Alright, so I was at my school (I didn't exist in this part), and Ryuga shows up. Gingka undigs 7 rubber bouncy balls and says he stole them from Ryuga when he was a kid, which does not make any sense as they just met, and then Kenta pulls out some thermometer and tilts it to the side, asking Madoka if she can do that. Then, Madoka starts randomly conducting an invisible orchestra. Now I am in my living room, on the old furniture no longer there, and my little sister is up watching some show for two-year-olds, then they ing a song and tilt their upper bodies to the left. My mom is doing an Internet, and stops and says that they always tilt because it represents healing (I was like ???). Then it ended.

^Dat wuz a dream^

Funny Quotes NEW QUOTES ADDED ALL THE TIME (Click to View)

hey ill give u an earth wheel for a ripcord

I wish Bey Brad could still eat people's families.

Now, I wonder where Daegor42 ran off to.....

I'm in Narnia. The internet connection here sucks.

Kids are so bad with. . . kids. . . toys.

i know epic underground cage matches like in the Hasbro commercial

what's anubis
is it the teddy bear with a scar on it's face?

thats what....she said?

I just told you your entire solution. I promote tournaments like crazy, I've gotten elementary school kids to do their homework twice as fast with Beyblading as a reward, and I can sell light bulb sockets to the Amish.

What more do you want?

You play Beyblade ... with ... anyone else who plays Beyblade.

It amazes me how many people are confused by this.

I believe this combo's success is based on the recoil of the opposing wheel. It uses it to force it out.

So it's a combo that only works against bad combos? Great.

Welcome to the WBO!
Make sure to read that PM when you first logged on.
Tonnes of info you need to know...to SURVIVE...on the WBO.
buahah..

yeah, to survive the ''Administrators/Moderators'' dunt dun duuuu (horror sound effect)....

...

It's a plastic model. You really don't want me to answer that question. rofl

Hi Roan,

It seems that you've accidentally found yourself in a topic you're not at all interested in. Please click http://forums.beywiki.com to return to the forums index.

Thanks,

Tamer Brad
Beywiki.com Staff

IMA KIK EVRYONEZ BUT!!! WOOOOOOOOOOOOOP!!!!!!!!!!!!! TWO MAN ARMY AGAINST ALL ME AND SHAREEF CUZIN AND CUZIN!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! WE WIL;L PWN!!!!!!!!!!!!

just a note to everyone reading this: this is real. [b]there is a real person who thinks like this.

There are very ignorant people here, though. I tried to help some kid here with combos because his combo was pretty bad. Then he just started going mad and he called me a 'Bossy Watermelon' or something like that.

*Crosses fingers for Damian to win*

You could fuse them together and Ginga would still win.

Step One: LED Sight
Step Two: Shine into other players eyes
Step Three: Victory

Someone ban this please.

Might as well ban the sun from tournaments while we're at it then.

no, because last time i checked, i can't move the sun INTO YOUR EYES

how do you battle

My MS that I bought tomorrow spin over 3 minutes if I don't hit it with other bey.

That doesn't make any sense.

I woke my son up the other day with a Basalt Horogium Vs Earth Eagle Bey Battle on his stomach! LOL

I am unable to post any results as the stadium woke up and ruined the battle.

I am sure this goes against all safe beyblading rules

On a ragged slide in the playground at school. This was a long time ago in elementary school (I think i was in 1st or 2nd grade?) in the good old days when plastic beys were found in local stores. All the 5th graders would be like "driger! tiger claw!" And then i would say "you know that doesn't work--" "YES IT DOES"

oh, silly upperclassmen.

Funny and classic threads (Click to View)

KIE-V why!!! THE CRAZY STORY friend >battle<
I STRIKE WITH EARTH VIRGO!Banned Beys FAIL. Is Kai a girl?Your toast

Statishicks (Click to View)

CLICK HERE, STORY WRITERS. IF YOUR STORIES ARE SIMILAR TO THIS, CHANGE THEM, OR STOP WRITING.

Just a plastic container lol

---

"Welcome to the end of your life, and I promise its going to hurt!"
-Vegeta
Thanks !Night for the Sig its great!

He said he put the parts in a container.

Honestly, driger s is definitely a bey worth digging for, even if it had issues, most of it's parts are amazing (heck, even if the base and ar are thrashed, if the tip is okay then pm me a picture cos I need a replacement tip having lost one).

---

th!nkBlargh|H-Code Product List

my S cracked when a n00b, my firend, used on the side walk

Depending on the type of container, it'll probably still be there (I'd think most plastic containers would survive that).

Get Digging!!! (no jokes, driger s is amazing and worth it, even if you only get the AR or something.

---

th!nkBlargh|H-Code Product List

Wow, that's quite an unusual break :o Closest I've had was on a sonokong gold driger s ar, the 3 of the 4 parts that poke up to prevent the smaller bit chips slipping out snapped off mid battle. I still haven't found the bitchip that went flying as a result.

A chunk of it that large snapping off isn't something I've seen before, and I've owned a lot of fake beys, so I've seen a few odd snaps :\

But this AR is a Takara AR, not a sonokong or a hasbro

I was trying to put together the bit, AR and the cover that covers and keeps the bit chip in the AR. But the cover thing couldn't go in because some of the little thing from the plastic where still there; you know when you open a Takara plastic beyblade box pack and the parts are suck together by those plastic stuff, yeah - I couldn't put the cover in because of that. I tried to remove it, I did but that part I took the photo snapped off.

I've pretty much given up trying to put my metal ball defencer together because I can't put the screw inside...and now the holder in the AR is snapped...

(T___T)

I guess I should find it.If I cant I could always buy a knew one,though I would be so exited to find the old one!

---

"Welcome to the end of your life, and I promise its going to hurt!"
-Vegeta
Thanks !Night for the Sig its great!

I guess I should find it.If I cant I could always buy a knew one,though I would be so exited to find the old one!

driger like others say is amazing but of what i can remember of my plastics years (oh the memory's sweet non stadium playing on books tables ect) and it is amazing to my last memory of it till that faithful day dragoon v2 broke the thing into many pieces and i picked him up and threw him out in a separate trash bag with his name in sharpy...why was i so dumb

---

Hue.

While not necessarily a "break" in the literal sense, my Sono Kong BB-10 Attack Stadium has become unreliable for consistent use, as it had an incident wherein I fell on it, today. This caused a noticable warp in the plastic near the TR, after I tried to pop it back into normal shape - I could technically heat the plastic and form it back to its original state, but I worry that may deform other parts of it further.

I do not have the money to replace it for a long while... so much for Beyblading.

---

Some manner of Octopus.

Wow, that's quite an unusual break :o Closest I've had was on a sonokong gold driger s ar, the 3 of the 4 parts that poke up to prevent the smaller bit chips slipping out snapped off mid battle. I still haven't found the bitchip that went flying as a result.

A chunk of it that large snapping off isn't something I've seen before, and I've owned a lot of fake beys, so I've seen a few odd snaps :\

But this AR is a Takara AR, not a sonokong or a hasbro

I was trying to put together the bit, AR and the cover that covers and keeps the bit chip in the AR. But the cover thing couldn't go in because some of the little thing from the plastic where still there; you know when you open a Takara plastic beyblade box pack and the parts are suck together by those plastic stuff, yeah - I couldn't put the cover in because of that. I tried to remove it, I did but that part I took the photo snapped off.

I've pretty much given up trying to put my metal ball defencer together because I can't put the screw inside...and now the holder in the AR is snapped...

(T___T)

Well, as I said, in the Plastics gen, Takara's plastics were less resilient than Hasbro's.

Real shame that, though :\

Hazel: NOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOOO!

---

th!nkBlargh|H-Code Product List

Being that I really had nothing to lose, I did try to warp it back into shape using a low flame, but that was a blind alley - I couldn't get a uniform curviture, so while it is not really worse than it was, it is certainly no better, and now it is less attractive and more noticable, to boot.

---

Some manner of Octopus.

Being that I really had nothing to lose, I did try to warp it back into shape using a low flame, but that was a blind alley - I couldn't get a uniform curviture, so while it is not really worse than it was, it is certainly no better, and now it is less attractive and more noticable, to boot.

i do that to hasbro stadiums all the time...but through battles with ridicules battles with blades that had h145 and bs often cyber or flame and almost always scorpion and aquario clear wheels and have a mf lld (sadly i have no mf-H 90 or 85 so 100 is my current best choice for this combo...darn hasbro for no new products with 90 or 85)rf or r2f and i have wrecked the TW in my thinner and huge stadiums...the only stadium so far capable of withstanding the hits is my trav. stadium

---

Hue.

this is what happens when you mess with Gravity Destroyer with horns Poor Leone

---

...? Exactly how did that happen?

---

Some manner of Octopus.

Not uncommon at all: Earth took one too many hits. After hundreds of battles, Earth's mold begins to deteriorate, obviously, but it is almost always in the same area: the wing is connected with the Face Bolt 'hole' as I like to call it, with much thinner metal. I'll edit this post with a picture of the areas affected.

Basically Earth breaks, that's it.

---

shout out 2 kai-v 2.

The Complete Competitive HMS Resource

Ah. I hadn't seen a report of a Mold 2 break in a long time - if ever. I'd assumed they were extremely uncommon.

Are they the same spots it weakens on in Mold 1? I am familiar with those.

---

Some manner of Octopus.

I've had it happen.
Could only get the mold 1 picture off beywiki.

personal Earth breaking points (Click to View)

[Image: picture2fje.png]

Yeah, that's where I had breaks..
By non-detrimental, I mean it is still usable with no actual difference in performance.

---

shout out 2 kai-v 2.

The Complete Competitive HMS Resource

Yeah, that's pretty much where I expected them to be. Oh well.

Shame to see a broken Earth wheel. I'd certainly be upset if either of mine broke.

---

Some manner of Octopus.

Trying a bad bey using a dark wheel against Meteo Striker
Bey using Dark just flies against the wall.
When I checked,Dark just had a huge dent.....
And my W105 wings broke.

Trying a bad bey using a dark wheel against Meteo Striker
Bey using Dark just flies against the wall.
When I checked,Dark just had a huge dent.....
And my W105 wings broke.

Meteo "striker's" illegal FYI.

---

Look at this (Click to View)

Thanks Angry Face :D
Plastics request thread, request your combo ||
What to Buy in Plastics || Plastic Parts Discussion|| Competative Heavy Metal System Combos|| HMS Parts Disscusion