Apparently I may have been sitting on drawings of some Hasbro products for a while hah. But it is not necessarily good news...
Firstly, here is a design where the BeyLogger is totally merged with a winder-based launcher, and somehow you can fit two together (litterally branch them to one another), probably to be able to launch two Beyblades simultaneously...
Secondly, here are two stadium designs for what looks like typically Hasbro cautious ideas, especially knowing that one of the official stadiums that should come out is called "Triangle Stadium" (thanks to Zankye's research) or something like that, therefore the second one would be a "Square Stadium".
No, these are not just stadium Covers upside down: this is the position they are supposed to be in - the centre is not a hole, it is full, slightly dipped, then the structure goes up for the Tornado Ridge (the big circle you see) and then way down for the pockets, with the pockets basically being the only contact with the ground or floor.
The slope is barely 10° on these, by the way... So, as flat as Hasbro's usual stadiums. Actually, even the Pegasus Thunder Whip Stadium from Beyblade: Metal Fusion had a slope of approximately 20°...
The small circles or holes around the perimetre are for installing obstacles or fences, things like that.
Keep in mind that I have no confirmation that these are designs that represent Hasbro Beyblade Burst products, but even if it is TAKARA-TOMY that is going to release these, personally it is bad hah. It could also be for something not Beyblade-related, another sort of spinning top by TAKARA-TOMY, but the resemblance is too high to speculate that way.
Firstly, here is a design where the BeyLogger is totally merged with a winder-based launcher, and somehow you can fit two together (litterally branch them to one another), probably to be able to launch two Beyblades simultaneously...
Secondly, here are two stadium designs for what looks like typically Hasbro cautious ideas, especially knowing that one of the official stadiums that should come out is called "Triangle Stadium" (thanks to Zankye's research) or something like that, therefore the second one would be a "Square Stadium".
[Image: PossibleHasbroBeybladeBurst_StadiumTriangle.jpg]
[Image: PossibleHasbroBeybladeBurst_StadiumSquare.jpg]
[Image: PossibleHasbroBeybladeBurst_StadiumSquare.jpg]
No, these are not just stadium Covers upside down: this is the position they are supposed to be in - the centre is not a hole, it is full, slightly dipped, then the structure goes up for the Tornado Ridge (the big circle you see) and then way down for the pockets, with the pockets basically being the only contact with the ground or floor.
The slope is barely 10° on these, by the way... So, as flat as Hasbro's usual stadiums. Actually, even the Pegasus Thunder Whip Stadium from Beyblade: Metal Fusion had a slope of approximately 20°...
The small circles or holes around the perimetre are for installing obstacles or fences, things like that.
Keep in mind that I have no confirmation that these are designs that represent Hasbro Beyblade Burst products, but even if it is TAKARA-TOMY that is going to release these, personally it is bad hah. It could also be for something not Beyblade-related, another sort of spinning top by TAKARA-TOMY, but the resemblance is too high to speculate that way.