(Aug. 25, 2019 1:28 PM)Ravinchen Wrote:(Aug. 25, 2019 3:11 AM)Rouzuke Wrote: I've seen Bladers use Blitz with Bearing on pP as well, and it does hold its ground quite nicely against opposite spin Bearing and Xt+, as long as the Layer you use with it is in mint to semi-mint condition for the teeth.I do funny enough but what disk is best for orbit metal then
I think Around is maybe a bit heavier or somehow in the same weight range as 00/0Proof with actual rolling balls on four points for minimizing scrape on low spins or negating heavy blows from underneath, and most often than not Bladers will have their Bearing combos on left spin for spin-equalization so the Around.Atomic might not be too favorable with opposite spin. Again, I'm interested to test this out when I get off work. I'm simply basing off from my previous part testings for Around and Atomic.
It also would depend on which Atomic recolor you're gonna use since some colors have better spring at the cost of less KO resistance due to freer-spinning balls, while others are KO resistant but have weaker springs. Same difference with other Drivers with free-spinning parts as well. If you're lucky, you could have an Atomic with both nice spring strength and moderately free-spinning ball tip.
Basically anything that used to be good with Orbit back in the God era prior to the inclusion of Atomic
