Hello guys, do you know if there's any way to unscrew a driver/performance tip (even if it's illegal) without damaging it?

google “screw extractor”

—-

i’ll take a guess that your desire to get inside the driver is related to atomic/orbit/yard sticking and not freely rotating? is that the case? or is it just for an aesthetic mod?

if it is about parts not freely rotating, that usually resolves itself with prolonged use, and you can speed the process up by rotating the parts in your hands for a long while.

No, no, not at all XD! I just have to replace a worn tip with some spare parts...

You can also use this to make the springs on Br stronger

I believe there was one YouTuber (either Super Beyblade Family or some Japanese Blader) who used a soldering iron to melt out the metal bits holding the Driver together. Not sure if this is the best idea, since it will probably be difficult to melt them back into their sockets after modifying the Driver, and it might also cause damage to the surrounding plastic if you aren't careful.

---

I believe there was one YouTuber (either Super Beyblade Family or some Japanese Blader) who used a soldering iron to melt out the metal bits holding the Driver together. Not sure if this is the best idea, since it will probably be difficult to melt them back into their sockets after modifying the Driver, and it might also cause damage to the surrounding plastic if you aren't careful.

This idea will work, get the thinnest possible soldering iron. I would recommend getting fakes and customizing the way you want, those use regular screws.

---

Hello guys, do you know if there's any way to unscrew a driver/performance tip (even if it's illegal) without damaging it?

If you take out the screws you'll destroy the whole driver.

---