Hello bladers! I was just wondering If any of you can help me fix Lord Spriggan, my Lord Spriggan does not click or does not have extra locks anymore, It's locks are just like regular bey locks with the dash drivers, can anyone please tell me how to fix it, I would really appreciate it. Thank you, also If there is no way to fix this, just tell me that it is broken, thank.
[Unanswered] Lord Spriggan stops clicking (help!)
You want us to tell you why your Spriggan is normal
(Sep. 25, 2019 11:03 PM)Ghostly Wrote: Hello bladers! I was just wondering If any of you can help me fix Lord Spriggan, my Lord Spriggan does not click or does not have extra locks anymore, It's locks are just like regular bey locks with the dash drivers, can anyone please tell me how to fix it, I would really appreciate it. Thank you, also If there is no way to fix this, just tell me that it is broken, thank.Just to be clear is the chip on
Try switching the chip to figure out if just your Spriggan chip is the issue.
maybe the Teeth have worn down
Yes, Yes, Yes... I have tried and see all that but all of these tips I tried don't work, and Teeth can't be worn down
The thing is that the driver is supposed to be stuck with the layer even If It's not locked together, mine doesn't do that...
The thing is that the driver is supposed to be stuck with the layer even If It's not locked together, mine doesn't do that...
(Sep. 25, 2019 11:59 PM)Ghostly Wrote: Yes, Yes, Yes... I have tried and see all that but all of these tips I tried don't work, and Teeth can't be worn downThere’s a little burst resistor that does that. It just wore down. It’s normal.
The thing is that the driver is supposed to be stuck with the layer even If It's not locked together, mine doesn't do that...
Check the two small plastic nubs on the sides that acts as the burst stoppers, is it worn down?
Also, what disk are you trying it with? Its only sticky with a few disks, not all of them will stick.
Also, what disk are you trying it with? Its only sticky with a few disks, not all of them will stick.
Specifically Sting, Around, and Blitz. 0 may work, depending on your mold.
(Sep. 25, 2019 11:59 PM)Ghostly Wrote: Yes, Yes, Yes... I have tried and see all that but all of these tips I tried don't work, and Teeth can't be worn down
The thing is that the driver is supposed to be stuck with the layer even If It's not locked together, mine doesn't do that...
Idk maybe you didn't fully click the right or left spin
In my case blitz and 0 sticks really well even the unpainted ones