Hey guys I bought a lot of beyparts and some of them have paint on them, what’s the best way to remove that paint?

Hey guys I bought a lot of beyparts and some of them have paint on them, what’s the best way to remove that paint?

I use Goof Off paint stripper. Take a piece of cardboard or something of the like outside, squirt Goof Off on one side of your parts, wait a bit, then squirt some on the other sides. The paint should peel up a lot, then you should be able to get it all off with a stiff brush, kind of like a toothbrush. I typically will soak them in paint thinner/turpentine for a good while to remove all the little fleks of paint that I missed and neutralize the paint stripper's solvent qualities, and then I wash the parts off, scrubbing thoroughly with dish soap.

Bonus: If you're removing paint from Fusion Wheels, they'll be kind of opaque and gritty afterwards. The solution to this (as well as a very similar problem caused by age) is wadding polish, my preferred brand being Eagle One Nevr Dull. Hand-buff your wheels with the stuff, wipe 'em off with a paper towel, and they'll look even better than when they were brand new! It works on forge discs from plastoc gen and Burst, too!

---

One must never, never, never rush the plumb bob~
Slow is the way, the only way to go~
Clear your schedule, before you use the plumb bob~
Yes, the plumb bob, is mighty, mighty, miiighty, sloooooooooooowww~

What about just using turpentine?

---

Hey guys I bought a lot of beyparts and some of them have paint on them, what’s the best way to remove that paint?

I use Goof Off paint stripper. Take a piece of cardboard or something of the like outside, squirt Goof Off on one side of your parts, wait a bit, then squirt some on the other sides. The paint should peel up a lot, then you should be able to get it all off with a stiff brush, kind of like a toothbrush. I typically will soak them in paint thinner/turpentine for a good while to remove all the little fleks of paint that I missed and neutralize the paint stripper's solvent qualities, and then I wash the parts off, scrubbing thoroughly with dish soap.

Bonus: If you're removing paint from Fusion Wheels, they'll be kind of opaque and gritty afterwards. The solution to this (as well as a very similar problem caused by age) is wadding polish, my preferred brand being Eagle One Nevr Dull. Hand-buff your wheels with the stuff, wipe 'em off with a paper towel, and they'll look even better than when they were brand new! It works on forge discs from plastoc gen and Burst, too!

What about just turpentine?

What about just turpentine?

Eh, you wouldn't get nearly as good of a result

---

One must never, never, never rush the plumb bob~
Slow is the way, the only way to go~
Clear your schedule, before you use the plumb bob~
Yes, the plumb bob, is mighty, mighty, miiighty, sloooooooooooowww~

What about just turpentine?

Eh, you wouldn't get nearly as good of a result

How about goobegone?

Eh, you wouldn't get nearly as good of a result

How about goobegone?

That'll just make them smell like dying ants

---

One must never, never, never rush the plumb bob~
Slow is the way, the only way to go~
Clear your schedule, before you use the plumb bob~
Yes, the plumb bob, is mighty, mighty, miiighty, sloooooooooooowww~

How about goobegone?

That'll just make them smell like dying ants

I used rubbing alcohol it’s super effective