---

Ouch,, yea,, sometimes when I'm really not in the mood for ones with more stickers than others or just harder ones to put on (cough bloody and nightmare longinus) i just wait to do it until i have a podcast to listen to or something else to keep it relaxing and a cup of tea lmao

I agree, music or a distraction on you tube helps too!
But then, sometimes it takes longer. Haha

---

I actually like to put on the stickers.

Use the tip of a knife. I just put the edge of the sticker on a knife and put the sticker where it goes and it’s easier than your fingers

---

Youtube Channel: BeybladeReviews - (Look for BR logo)

I use tweezers, but the edge gets sticky & makes the stickers harder to remove from the tweezers - then I use a toothpick also & constantly clean the tools. I just did the whole 8 pack of boosters from the Air Knight set & they had some itty bitty stickers.

---

Use the tip of a knife. I just put the edge of the sticker on a knife and put the sticker where it goes and it’s easier than your fingers

I used to have a job as a knife salesman, so I have some high-quality kitchen knives that are really good for this that I used to show off to customers. The paring knife in particular is good for getting those more irritating stickers in place, such as the stickers on the inside of Air Knight's fans.

Really though, I only use this if the sticker is in a hard to reach area or gets slightly misplaced. If it's easy enough to access I'm better off doing it by hand.

---

Cincinnati-based Organizer, and owner of every single currently released TT Burst bey part in at least one color. Hard to think of anything I don't have from MFB either...

I use one of these for applying stickers along with cotton q-tips and toothpicks to press in the fine details.



but thats coming off a lot  of gunpla building experience

---

I use one of these for applying stickers along with cotton q-tips and toothpicks to press in the fine details.



but thats coming off a lot  of gunpla building experience

Oh ho... a fellow gunpla builder, I see

I also use tweezers, q-tips and toothpicks as well. I just put red markings on the metal grooves of the Layer (like CZ-A's metal blades) just so it would look nicer with more reddish accents

---

Ore wa tsuyoi da

IG: @kinghadoukenbeypla
(I try to post daily for things like Beyblade and Gunpla)

The few times I buy TT I just discard the stickers. That way it stands out from my Hasbeys more obviously and I don’t have to worry about the work.

---

oh no i just woke up and two years have passed where am i what happened

I'll use a combination of straight and angled tweezers. But truth be told, I'll often hand over the stickers to the wife. She's better at it!