I bought a "colorful" dragon MF for 80 bucks, and decided to repaint it.

How does it look?

https://imgur.com/gallery/VzPSF

The paint seems quite uneven and also there are chips in it. The RC needs more paint. Would advise on several thin coats if you paint another beyblade. Also you should have put primer down because it looks a bit off since all the plastic isn't the same colour so it's not all going to look the same.

---

i think its almost impossible to not have chips around the bit unless the paint is extremely thin.

Since my bit and AR was black, thin paint didn't help much, especially since i was coloring it white.

Oh and i did use Primer! But it was too heavy, that's where i screwed up..

Thanks for the constructive criticism

The AR and WD look splendid! Just fix the BP and RC a little and you're good to go!

---

                                                                                                                 

i think its almost impossible to not have chips around the bit unless the paint is extremely thin.

Since my bit and AR was black, thin paint didn't help much, especially since i was coloring it white.

Oh and i did use Primer! But it was too heavy, that's where i screwed up..

Thanks for the constructive criticism

What kind of paint did you use? How did you apply it?

Also you're kind of sending mixed messages. You say the bit and AR was black but you also say you used primer which should have covered that up. 
As for the paint chipping thing have you seen Dio's customs? Cause that's clearly not true.

---

This should be posted in the following topic:
https://worldbeyblade.org/Thread-Your-Re...omisations