A mold God Chip and why it is tighter. - Printable Version +- World Beyblade Organization (https://worldbeyblade.org) +-- Forum: Beyblade Discussion (https://worldbeyblade.org/Forum-Beyblade-Discussion) +--- Forum: Beyblade Customizations (https://worldbeyblade.org/Forum-Beyblade-Customizations) +--- Thread: A mold God Chip and why it is tighter. (/Thread-A-mold-God-Chip-and-why-it-is-tighter)

A mold God Chip and why it is tighter. - Shindog - Jun. 13, 2020 I search the forum and found instances of people claiming A mold God Chips makes beys tighter but I did not really find the why.  Maybe I didn’t search hard enough but I decided to investigate a little: Red is A mold and purple is not Blue is A mold and the Green is a MGC Orange in the middle is again A mold, yellow is not and green is again MGC. Now, when A mold is installed on a mG layer: This is an mG with A mold God Chip Here is mG with stock God Chip.  I did the same measurements on a Deep Chaos layer with an A mold gold chip and a B mold god chip and found the difference to be one hundredth of a mm.  In testing the Deep Chaos layer with different God chips I really didn’t see much improvement in burst resistance with an A mold God Chip vs with a B mold god chip.  However, on mG with A mold God Chip I saw this: mG and A mold God chip (the beginning of the video I used stock God Chip and half way I switched to A mold) https://youtu.be/2IafgGeN_rM I will post measurements on the God chips themselves here: The outer ledge of A mold God chip The outer ledge of a C mold God Chip Besides having a dramatic effect on mG, I haven’t found the A mold to perform very differently than B and C mold personally on other layers.  Would love to hear any different opinion and thoughts. RE: A mold God Chip and why it is tighter. - kai edits - Jun. 24, 2020 I put a mold god chips on my bey but it's not tight is this a defect god chip RE: A mold God Chip and why it is tighter. - Yalldodo - Jun. 24, 2020 idk but my god chip is not tight so is it a defect too?