Electric Driver Ideas - Printable Version +- World Beyblade Organization by Fighting Spirits Inc. (https://worldbeyblade.org) +-- Forum: Beyblade Discussion (https://worldbeyblade.org/Forum-Beyblade-Discussion) +--- Forum: Beyblade General (https://worldbeyblade.org/Forum-Beyblade-General) +--- Thread: Electric Driver Ideas (/Thread-Electric-Driver-Ideas) Pages:
1
2
|
Electric Driver Ideas - ReekoBlader - Nov. 17, 2019 This thread is for discussing electric driver ideas. Please feel free to post any idea you have for a new electric driver. Electric driver name: Hyper Driver initial: Hp Weight: 24g Description: a somewhat lightweight E-driver, with a powerful variable motor and a tip that has the rubber of Xtreme’ And the diameter of assault. It’s motor RPM will vary , based on how hard the Beyblade is launch. RE: Electric Driver Ideas - HappyRhino - Nov. 22, 2019 Aerial: Driver initial: Ae Weight 23g Description: a driver that constantly raises and lowers, creating a movement pattern that is very unpredictable and a beyblade that jumps and trembles around the stadium. This is like a motorized driver that is supposed to have the result of a vamped up quake. RE: Electric Driver Ideas - Armor - Nov. 22, 2019 Name: Cyclone Driver Initials: Cl Weight: 35g Description: Using a Unite like tip, the rubber part is shifted randomly up and down. As the electric drivers seem to be destabilized very easy, the tilting will cause the rubber to touch the floor, causing an acceleration. The rubber will recede when the combo is well balanced. P.S. I'm assuming these are disc and driver combos? If so, you may want your drivers to be heavier HappyRhino ReekoBlader RE: Electric Driver Ideas - Spider Sniper - Nov. 22, 2019 Rush: Driver Initial: Rh(Rs is taken by Rise) Weight: 25g Description: A driver that when first launched, it becomes flat(ultra attack) and "rushes" around the stadium but later a metal stick comes out(attack) and the motor makes it spin so that it can go around the stadium in a flower pattern. RE: Electric Driver Ideas - ReekoBlader - Nov. 22, 2019 Name: Bulwark Initials: Bw Weight: 40g Description: a heavy driver with a rubber tip similar to Kp. Containing a sensor that determines how fast the bey is spinning, once the bey is launched, and it hits the right RPM, it’ll nullify the beys spin by rotating in the opposite direction. Causing it to be planted to the stadium, creating exceptional defense Example: the beyblade being used is a right spin, (the driver can be switched from right to left) If launched hard in the stadium, once the sensor senses The right RPM, it switches itself on and the driver tip will spin left at the same exact RPM as the bey spins right, thus canceling itself out, causing the tip to be perfectly still on the stadium. If the beyblade is a left spin, the example will be mirrored and reversed RE: Electric Driver Ideas - BloodyPhoenix - Nov. 23, 2019 Name: Dive Initials: Dv Weight: 21 Grams Description: A fairly lighter driver that has a rubber tip that extends from the main "bulk" of the driver. The driver will first push towards the edge of the stadium, then circle around the ridge in a defensive manner. It will then stall at the ridge using the rubber as a brake, then will dive towards the center of the stadium at high speed using the same rubber offensively. RE: Electric Driver Ideas - ReekoBlader - Nov. 23, 2019 Name: Vibe Initials: Vb Weight: 30g Description: a decent weighted E-driver with a tip resembling Yielding, instead of it having a rotary motor, (Like Hy & Ig’) It has a high-speed magnetic solenoid that extract and detract the tip at extremely high rate, that it vibrates, like a metal engraver. Which in turn causes the beyblade to vibrate across the stadium (just like a vibrating phone will move on a surface because each little vibration causes the phone to jump and be airborne... that’s the tip in-a-nutshell!), cutting its friction drastically, giving it excellent stamina! But it’s weakness is that it has almost no KO resistance. RE: Electric Driver Ideas - Rouzuke - Nov. 23, 2019 Name: Glide Initials: Gl Weight: ~30g Description: basically a Hybrid with more sleek but thick metal plates underneath (like Octa) for smoother and better LAD as well as better protection from opposing impacts, and the dome POM tip has a free-spinning plastic plate akin to Revolve but at a smaller diameter to let it glide back up when destabilized at lower RPM. The rotary motor activates twice on hard launches (1st to stall, 2nd for regaining a few more spin time at low RPM), and activates once for moderate and weak launches. RE: Electric Driver Ideas - UltimateMaster - Nov. 24, 2019 Name: Flight Initial: Fl Weight: 40g Description: Similar to most infinite lock drivers except it has a tip similar to unite with a metal center and soft rubber: RE: Electric Driver Ideas - Ardmore Bladers - Nov. 24, 2019 Name: Elude Intials: Eu Weight: 34 Grams Description: a lighter weight driver with a rubber ball tip akin to Keep. When launched, the rubber ball will rotate like Hybrid, and move around just enough to “Elude” a mobile attacker such as Judgment Xtreme’. When both beyblades begin to slow, the beyblade with Elude will plant itself in the center, avoiding any late game KOs. RE: Electric Driver Ideas - KnightPro - Nov. 24, 2019 Electric driver name: Wheel Driver initial: Wl Weight: 28 grams Description: Similar to the liner driver and the same shape except the wheel is motorized. When launched it actives immediately and causes the bey to jump around and spawn erratic movements. It would be a good driver to put on the evolution of minoboros. RE: Electric Driver Ideas - bekfastblader - Nov. 24, 2019 Name: Rapid Initials: Rp Weight: 38 grams Description: This driver is similar to Hybrid, except it has a rubber tip like Unite, and can spin in any point e.g. NE, SE, SW, NW, N, S,E,W amd such. It can also spin at 3 levels: Spin-steal, fast, or normal. This would be good on zwei of judgement diabolos RE: Electric Driver Ideas - DeltaZakuro - Nov. 25, 2019 Name- Hydraulic' Initials- Hd' Weight' 36 Grams it functions very similarly to Trick where it changes modes randomly, this Driver can change between Attack, Stamina and Defense mode all at the same time battle. (Nov. 25, 2019 1:43 AM)DeltaZakuro Wrote: Name- Hydraulic' RE: Electric Driver Ideas - MWF - Nov. 25, 2019 Name- Flux Initials- Fl Weight- 50 grams It has an electromagnet inside that triggers at high velocities to repel the low angle cone tip to allow it to free spin and absorb bounces like nothing without the stamina drain of being unstable. Once it starts to slow down the driver turns off and the magnet attracts to the heavy metal core. The driver drops to a lower height and stops free spinning. RE: Electric Driver Ideas - lilphilyb - Feb. 04, 2020 I am reviving this thread cuz I got an idea for an electric driver Driver name: Revolt' Driver initials: Rv' Weight: 60 grams It works like reboot, when launched, Revolt' moves an a semi aggresive pattern, when the tip goes down, it moves like a volcanic. RE: Electric Driver Ideas - The Rex - Feb. 04, 2020 I have one Name:Nightmare Initials:NM Weight:30 grams First it starts attacking and does super strong attacks.Then when it gets weaker it goes into a defensive stance.Then when it gets enough spin it goes back into a super attack mode. Sorta like Ldrago Destroy and Master Diabolos Also the electric driver causes it to steel the other beys power and makes it it’s own RE: Electric Driver Ideas - Nik P. - Feb. 04, 2020 (Feb. 04, 2020 1:45 AM)The Rex Wrote: I have oneIsn’t that like tower from shelter regulus but better RE: Electric Driver Ideas - MagikHorse - Feb. 04, 2020 (Feb. 04, 2020 1:45 AM)The Rex Wrote: Also the electric driver causes it to steel the other beys strange and makes it it’s own What is "another bey's strange", and how does it steal it? RE: Electric Driver Ideas - ReekoBlader - Feb. 04, 2020 (Feb. 04, 2020 6:50 AM)MagikHorse Wrote:(Feb. 04, 2020 1:45 AM)The Rex Wrote: Also the electric driver causes it to steel the other beys strange and makes it it’s own I think he meant “strength”... I think... And how it does that.... idk... Rex, you have to explain the mechanisms that make it “Steel the other beys strange” RE: Electric Driver Ideas - bekfastblader - Feb. 04, 2020 Deflect: 40 (normal) 60 (with pieces out) Dfl This is a REALLY TALL driver+disc that use metal all around it so when beys hit, it, it does either no or little damage. This metal piece pops out randomly at different points of the battle, then when at super low stamina, it attacks with relentlessness and possibly breaks a bey. P.S. the height is as tall as Bullet with a slight more height RE: Electric Driver Ideas - The Rex - Feb. 04, 2020 (Feb. 04, 2020 6:50 AM)MagikHorse Wrote:(Feb. 04, 2020 1:45 AM)The Rex Wrote: Also the electric driver causes it to steel the other beys strange and makes it it’s own The electric parts in it causes it to steal spin RE: Electric Driver Ideas - MWF - Feb. 04, 2020 Overdrive (Ov) A stamina type disk/driver with a Low angle cone tip and a smooth shape like Ignite. When launched the motor inside starts spinning up an internal metal ring. This greatly improves balance via the flywheel effect. RE: Electric Driver Ideas - MagikHorse - Feb. 04, 2020 (Feb. 04, 2020 12:09 PM)The Rex Wrote:(Feb. 04, 2020 6:50 AM)MagikHorse Wrote: What is "another bey's strange", and how does it steal it? How would it do that? It's contact with an opponent that allows equalization, so is this thing large enough to provide contact points? If so, that defeats the point of having a motor as eventually the motor will kick in, you'll speed up, and start to give power back to your opponent instead, unless it's the contact points that are motorized somehow? Like, this idea is stupidly vague. It needs a lot more than just "It does X". RE: Electric Driver Ideas - ReekoBlader - Feb. 04, 2020 (Feb. 04, 2020 12:09 PM)The Rex Wrote:(Feb. 04, 2020 6:50 AM)MagikHorse Wrote: What is "another bey's strange", and how does it steal it? Uhh... I don’t think u understand the science behind “spin stealing”... spin stealing happens when a bey comes in contact with a lower rpm opposite spin bey, when the high rpm bey makes contact, the friction that’s made causes force to be transferred from the high rpm bey, which slows it down, to the low rpm bey, which speeds it up... This usually happens by layer to layer, or layer to forge disc contact, but not layer to driver contact, Drivers do not cause beys to spin steal... The only thing the driver does is it either makes spin stealing easier or harder, but if u don’t have a layer that can spin equalize, it does nuffin... You have to be very specific with the details & mechanisms of your E-Driver if you’re gonna post it here, as I made this thread for E-Drivers that can actually be made, and that can actually work, IRL, not fantasy Drivers that’ll only work in the anime. we not only need to know What it does, but also How it does it, your entire post just said what it does, without any form of explanation on how it does it! We don’t even know what shape the tip is... RE: Electric Driver Ideas - GreenK9148 - Feb. 04, 2020 Name: steel Weight: 101 grams Initials: sl Description: very tall and can make contact with other layers, is all metal. There is a rubber ring at the tip of the driver and the motor spins the rubber ring. |