(Sep. 15, 2010  10:34 PM)greekboy148 Wrote: erm

(Sep. 15, 2010  10:44 PM)Mc Frown Wrote:

(Sep. 15, 2010  10:34 PM)greekboy148 Wrote: erm

I don't get the point of the ball bearings.
Besides, wouldn't they just make it heavy and difficult for the bey to jump?

(Sep. 15, 2010  10:59 PM)L-Drago Wrote: Omega has the best one yet, the others are really badly made drawings.. no offense I'm doing mine in the utmost care

(Sep. 15, 2010  11:01 PM)sadrak11 Wrote:

(Sep. 15, 2010  10:59 PM)L-Drago Wrote: Omega has the best one yet, the others are really badly made drawings.. no offense I'm doing mine in the utmost care

have u seen mine

(Sep. 15, 2010  10:10 PM)Black-Blade Wrote: Final idea , Carnaged Seth SW110 GS

"Preview"

SW110-Slaughter wing

GS-Genocidal slaughter

---

Tell me what you think about the name guys.

(Sep. 15, 2010  10:34 PM)greekboy148 Wrote: http://www.flickr.com/photos/53972311@N04/4994224314/



1: Wheel: Angered

Angered is based on pure upper attack. The low slops lift up opponents with ease. If the opponent is the same height, Angered can be used for smash attack. All of the weight is focused on the outside.

2: Clear wheel: Spirit

Spirit was designed with speed in mind. It is light weight and the little weight is foucused evenly around the outside, to increase speed.

3: Track: 90uj (Up jump) (Sub sections: 4, 5, 6, 7, 8, 9

90u is designed to "jump" once a certain amount of pressure is applied to the wheel . Once Angered Spirit 90ujtmwhf lands, the jumping part retracts back into the track to allow the beyblade to spin normally.

4: Small holes with simple covers are place into the sides of the track by the ball bearings to allow the user to lubricate the ball bearings. Remember to close the flaps!

5: the clips inside the track (Above ball bearings) will hold the jumper in place while the beyblade spins. This will release once a certain amount of pressure is applied to the track while the Wheel picks up the opponent. It will release the jumper and allow the bey to "jump". Once the jumper is pressed back into the track, the clips hold it in place to allow the bey to continue spinning at the normal height of 90.

6: The spring is used to launch the jumper out of the bey.

7: Rubber has been applied to the tip of the jumper so that once the bey lands back on the stadium, the amount of impact is reduced, resulting in minimal rotation loss.

8: The ball bearings will allow the jumper to move with ease and retract with ease. There are four on both sides, eight in total.

9: (Not on picture) The Jumper (Located above rubber, under spring and in between both bearings.) is what allows the beyblade to "jump". Because of the clips and spring, the jump can be preformed multiple times through the battle.

9 & 10 (Original 9 & 10, Now 10 & 11) : Bottom or performance tip : Thick Metal Wide hole flat (tmwhf)

The whole bottom is made of pure metal to reduce the chance of breaking. Because it is made of metal, it increases the beyblade's spin time. The Wide hole has two functions. To increase the spin time even more, and to allow the jumper to poke through the hole to create the jumping ability. It also hols the jumper in place while it flies out/retracts to prevent any damage to the jumper from landing at an angle.


EDIT!!!!


Ancient Egyptians believed in spirits, and if the body was tampered/damaged on purpose/things stolen/ect. The spirits would get angered. That is why this bey is called "Angered spirit"


Pros:
- Because of the weight focused around the outside, it can move quickly around the stadium.
- The jumping ability can make the blade toss opponents or even land on them is they get away quickly.

Cons:

- The angle of the jump can make the blade hit walls or even jump out of the stadium.
- If the blade lands incorrectly, the rubber tip will stick out of the hole, taking away the jumping effect and the added stamina ability.
- If the bearings are not lubricated, the jumper might not release or retract into the track.

End of edit

I was running out of time . So Face and complete bey will be posted in a quote once those are ready. Also, i will color this as well and post it in the quote

(Sep. 15, 2010  11:23 PM)ginka 100 Wrote: HOW TO CUSTIMIZE

(Sep. 15, 2010  11:23 PM)Ultimate_Blader Wrote: Here is My Beyblade, Watch "My Beyblade That I Made" http://www.youtube.com/user/DarkWolfKai?feature=mhum

(Sep. 15, 2010  11:24 PM)Black-Blade Wrote: The face is now partly revealed before the drawing , it shows an altered form of the eye of Horus , no more spoilers , I promise.

Any ways , back on topic , how do ball-bearings cause jumping ?

(Sep. 15, 2010  10:59 PM)L-Drago Wrote: Omega has the best one yet, the others are really badly made drawings.. no offense I'm doing mine in the utmost care

(Sep. 15, 2010  11:53 PM)Sora. Wrote: Here's my entry! Flare Ra 75WRF/WBD!

http://i869.photobucket.com/albums/ab254/antdojo/PresentationTemplate-1.png

Hope you all like it!

(Sep. 15, 2010  11:53 PM)Pyro Wrote: Mines doesn't look to bad

---

(Sep. 15, 2010  11:53 PM)Sora. Wrote: Here's my entry! Flare Ra 75WRF/WBD!

http://i869.photobucket.com/albums/ab254/antdojo/PresentationTemplate-1.png

Hope you all like it!

(Sep. 15, 2010  11:53 PM)Sora. Wrote: Here's my entry! Flare Ra 75WRF/WBD!

http://i869.photobucket.com/albums/ab254/antdojo/PresentationTemplate-1.png

Hope you all like it!

(Sep. 15, 2010  10:59 PM)L-Drago Wrote: Omega has the best one yet, the others are really badly made drawings.. no offense I'm doing mine in the utmost care

(Sep. 16, 2010  12:16 AM)Fayt Wrote: [img]"C:\Documents and Settings\Owner\My Documents\My Pictures\Picture 020.jpg"[/img]