World Beyblade Organization by Fighting Spirits Inc.

My h145 unscrews durng battles(hasbro) and my L-Drago's cw is loose with MFs(still hasbro...)

(Sep. 30, 2011  9:00 PM)TheInGreek Wrote: [ -> ]My h145 unscrews durng battles(hasbro) and my L-Drago's cw is loose with MFs(still hasbro...)

Wow hasbro seems to have more problems then TT.
I have a fury that doesnt take any clear wheel besides capricorn (hasbro) And on my R2F insted of having an indent in the center it has a little point and it sourta makes it move like an RS (hasbro).

(Sep. 30, 2011  9:36 PM)beyblades 2010 Wrote: [ -> ]

(Sep. 30, 2011  9:00 PM)TheInGreek Wrote: [ -> ]My h145 unscrews durng battles(hasbro) and my L-Drago's cw is loose with MFs(still hasbro...)

Wow hasbro seems to have more problems then TT.
I have a fury that doesnt take any clear wheel besides capricorn (hasbro) And on my R2F insted of having an indent in the center it has a little point and it sourta makes it move like an RS (hasbro).

1. fury isnt good(correct me if wrong)
2. rubber is hasbros weakness.
WHYYYYYYYYYY HASBRO WHYYYYYYYYYYYYYYYY!!!

---

My ch120 is not tight, and in battles, i hear it shaking when in Lightning L-Drago CH120 RF

A year back, being the Defense Blader I am, I was in desperate need of an Earth fusion wheel and a WD Performance tip. As I looked in Walmart I found an Earth Eagle (Hasbro) that was missing Half of it's Face Bolt, and it's Spin Track ENTIRELY. I tried to get a Discount, but the cashier was an IDIOT!

"It works just fine!" he said!
"It's missing half of the bolt, and it's track ENTIRELY!" I replied.
"Just use duct tape!" he said back.

And in frustration from his idiocy, I walked out of the store, empty handed. Oh yeah, and someone must of dropped their Earth Eagle on the ground, outside.

[ GRAVITY FOUND A Earth Eagle 145WD! ]
[The Beyblade was added to your Roster]

Holy you complain alot.

And that belongs here

(Oct. 01, 2011  2:29 AM)Shabalabadoo Wrote: [ -> ]Holy you complain alot.

And that belongs here

The point is that there was Half of the Facebolt missing, and no Track. Can't I put a little Backstory into how I found it? Also, did I ever say" I MAKING A COMBOOOOOOOLOLOLOLOLO" in there? EhehehehNO. Think about what it is you wan't to criticize before doing so. It will make you seem much less judgmental.

i bought a ray striker and when i got it i didn't know what cs was supposed to do then i figured out the fact that it had 2 cm of extra rubber on it so it was just like rubber flat

My friend hates beyblades, and came to my house and was like " Die beyblade " and the beyblade was like " Not today "..... LOL, but my Basalt came 2 days ago, but it came with a Light Launcher 2????? Wat da heeeellll????

BB-104's are meant to come with a Light Launcher 2...

Lets see:

~ You know those walls on the Hasbro MWs? the little notches protruding from the bars where the CW's notches fit? Yeah, for some reason my Rock that I traded a Flame for had them as if it was left spin

~ AND my 145 is near impossible to separate a Tip from. I need to heat the tip for a while and whack it a few times before I can take it off...

---

(Sep. 04, 2011  6:49 PM)Pcyborg Wrote: [ -> ]I have a Basalt with an air gap. It weighs 45 grams and you can see two small holes. its so bad that a single hit usually makes it so unbalance that it dies...

If one hole's in the CW, and Another in the MW, it's supposed to be like that.

He said a BASALT with the air gap.

(Oct. 01, 2011  10:40 AM)UltimaPegasus Wrote: [ -> ]~ AND my 145 is near impossible to separate a Tip from. I need to heat the tip for a while and whack it a few times before I can take it off...

Really? Mine is the complete opposite, it just is easy to pull on and off.

I bought a mercury anubis a few months ago on ebay and it came with gravity perseus stickers

hope your mercury anubis came with a tattoed face then...

My AD145 is White??????? What the heck Happened Did that ever happen to You?

---

(Jul. 14, 2011  11:19 PM)FlyingWaffle Wrote: [ -> ]My DF145 causes wichever bey it is on to rattle... it doesn't let the facebolt tighten enough.

Mine Does The Exact same thing, its annoying.

My Galaxy pegasis W105 and R2F were REALLY hard to put together right out of the box, now its fine because i kept turning it back and forth to weaken the plastic a bit

I'm not sure if this is a manufacturing error, but for some reason, I can't switch my Phantom wheel into attack mode properly! Whenever I attempt to do this, the core always ends up being "uneven" with the wheel.

My ED145 from Screw Lyra can pop apart easily. As in you can remove the free spinning part from the track without even trying. My ch120 I got to replace my broken one switches modes in battle, as common an issue as that is.
Something very odd, is that only one of my three hasbro M145 jumps between modes. And the two that don't are both from a storm capricorn.

(Oct. 01, 2011  12:38 PM)d^_^b Wrote: [ -> ]

(Oct. 01, 2011  10:40 AM)UltimaPegasus Wrote: [ -> ]~ AND my 145 is near impossible to separate a Tip from. I need to heat the tip for a while and whack it a few times before I can take it off...

Really? Mine is the complete opposite, it just is easy to pull on and off.

NOT THE TIP!!! It's the 145!!!

A good manufacturing error! My RF has a bar but alas, broke.

I actually got a error on the Takaratomy Random booster 8.I got screw fox but the stickers on the face bolt was badly positioned that you only can see 3/4 of the motif when putting on a beyblade.Nothing is perfect is it...

Eh? Stickers you just put it yourself. Your fault actually, unless both stickers are cut 1/4.

oh sorry i didint mean on the Bey. I meant the stickers that are on the sheet.You can still see a bit of the logo sticking out on the remainings XD

Edit:logo not motif sorry

My LLD's HF has a rectangular, skinny hole, not a wide circle hole.

My Rock Zurafa's Rock Wheel is loose -.-