+- World Beyblade Organization by Fighting Spirits Inc. (https://worldbeyblade.org)
+-- Forum: Beyblade Discussion (https://worldbeyblade.org/Forum-Beyblade-Discussion)
+--- Forum: Beyblade General (https://worldbeyblade.org/Forum-Beyblade-General)
+--- Thread: Gekiryu & UFD remold (/Thread-Gekiryu-UFD-remold)
Gekiryu & UFD remold - Pich - Mar. 19, 2009
Here are some comparison pictures of the Bistool remold and Gekiryu new mold. Keep in mind, my Bistool is older and worn, while my Gekiryu is about a year old.
So, Gekiryu performs just slightly better when used with 10b as opposed to using the remold Bistool AR. We should test the performance on a spin stealer/zombie custom as well. So, yeah, Discuss and prove or disprove this. We need to figure out how to put this in the wiki and thouroughly test this new mold AR out.
Oh, and here are some pictures:
[Image: DSCN0233.jpg]
[Image: DSCN0240.jpg]
[Image: DSCN0242.jpg]
[Image: DSCN0250.jpg]
RE: Gekiryu & UFD remold - Synesthesia - Mar. 20, 2009
The difference in performance is so barely noticeable, that I don't even know where to start, honestly.
RE: Gekiryu & UFD remold - Pich - Mar. 20, 2009
Maybe we shouldn't add that there is even a different mold then? I mean, it's already confusing enough and the new mold isn't much better (as far as we know). I wouldn't really know where to start, either. =/
RE: Gekiryu & UFD remold - Synesthesia - Mar. 20, 2009
The mold difference isn't the issue because it's fairly obvious close up that they are different. I just don't think there's enough evidence yet that one is better than the other.
RE: Gekiryu & UFD remold - Pich - Mar. 20, 2009
Yeah, your right. I probably will do a bunch of testing tomorrow, then.
RE: Gekiryu & UFD remold - G - Mar. 20, 2009
Get a side picture and compare from that.