+- World Beyblade Organization by Fighting Spirits Inc. (https://worldbeyblade.org)
+-- Forum: Off-Topic Forums (https://worldbeyblade.org/Forum-Off-Topic-Forums)
+--- Forum: Your Creations (https://worldbeyblade.org/Forum-Your-Creations)
+--- Thread: 3D Printing Maiden testing/discussion (/Thread-3D-Printing-Maiden-testing-discussion)
RE: Maiden testing/discussion - TitanDragon - Oct. 05, 2022
Is it possible to create 3D beys based on realistic models
RE: Maiden testing/discussion - kai edits - Oct. 05, 2022
(Oct. 05, 2022 9:58 PM)TitanDragon Wrote: Is it possible to create 3D beys based on realistic models
Idk
this is a testing thread for my bey
RE: Maiden testing/discussion - kai edits - Oct. 09, 2022
Death maiden illegal kick (no armor mode and armor mode) vs Hyper Maiden sting Quattro dash -2(high mode)
Same launchers and stadium of the last testing
Round 1-5 metal ball for Quattro dash
Rounds 1-5 left spin for hyper maiden
Rounds 1-4 armor mode for death maiden
Round 1 hyper maiden spin finish
Round 2 death maiden stadium out
Round 3 hyper maiden burst
Round 4 hyper maiden spin finish
Round 5 hyper maiden burst finish
During round 5 hyper maiden broke death maiden.
during rounds 3-4 death maiden began to shake a lot more than usual but I thought it was the because of my launch
Hyper maiden win rate 95%
Death maiden 5%