![]() |
Ask a question, get an answer! - Printable Version +- World Beyblade Organization (https://worldbeyblade.org) +-- Forum: Beyblade Discussion (https://worldbeyblade.org/Forum-Beyblade-Discussion) +--- Forum: Beyblade General (https://worldbeyblade.org/Forum-Beyblade-General) +--- Thread: Ask a question, get an answer! (/Thread-Ask-a-question-get-an-answer) |
RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Seldia Wrote:Do MS beyblades, specifically Dranzer MS come with bit chips? Or do they use a different system for that and if so does it have a image of the bit beast like previous versions? They use Bit Protectors, which act as screws to hold the Beyblade together. The first few had bit beasts on them, but the majority just have emblems. RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 Is it possible to put an old bit-piece in? Or would that mean chopping up a bit-piece and is that legal? XD RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Seldia Wrote:Is it possible to put an old bit-piece in? Or would that mean chopping up a bit-piece and is that legal? XD No, it's impossible. Can someone here take a picture as comparison? RE: Ask a question, get an answer! - AnnieDuck - Apr. 24, 2008 HMS are waaay smaller than the old plastic gen. Not possible, especially since BPs are needed to actually keep the top together. RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 I'll be buying a dranzer MS anyway, I just wanted to know ![]() RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 way way smaller RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 Right, ok ![]() ![]() RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Uh, it would depend on which one. People have gotten 4-5 minutes. RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 Dranzer MS ![]() RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Well Dranzer MS has two different modes ... why does it matter? RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 Curiosity? What do you mean by two different modes? (Again, sorry for the barrage of questions but I've been out of the loop for a while ![]() RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Dranzer MS's tip can be changed to attack (flat) or survival (sharp). Obviously flat has short solo spin time, sharp has high. The balance is pretty bad though. Either way it's a pretty poor blade and solo spin time is essentially meaningless. RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 I know, it's just something I like to know about beyblades, I am a fan of endurance for some reason ![]() ![]() RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Dranzer MS does not have a free-spinning tip. Also, solo spin time has nothing to do with survival (endurance). Wolborg MS doesn't have high spin time solo, but in battle it is the best survivor. Survival is about spinning a long time while being hit, not spinning a long time solo. RE: Ask a question, get an answer! - Seldia - Apr. 24, 2008 Ah, I was reading a review after searching Dranzer MS and it took me to information about dranzer MF not MS. Sorry about that ![]() P.S. Endurance by definition means how long it could last for, I used it literally forgetting it had a different meaning in blading, thanks XD RE: Ask a question, get an answer! - G - Apr. 24, 2008 Just so you know, you don't need to apologize for asking a lot of questions. This topic is here for questions. Dranzer MF has a spin free tip, but it's not as great as Wolborg MS's or Jiraiya MS's. RE: Ask a question, get an answer! - Pich - Apr. 24, 2008 I'm going to be getting a bunch of new HMS and since I know nothing about them, I want to know some good combos. I have/am getting... DEMS Sea Drake Thunder Serpeant (2) Advance Averager Advance Guardian Draciel MS Hopper Attacker and Wyvern DJ (AR only) So what is the best I could do with these? RE: Ask a question, get an answer! - Ryuuga BB Ruler - Apr. 24, 2008 I got a question and it bug me for awhile now, Do you use a screwdriver to take off your running core and put it on your other beyblade? RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 You need to get Wolborg MS. RE: Ask a question, get an answer! - AnnieDuck - Apr. 24, 2008 No. RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Blading Wrote:I got a question and it bug me for awhile now, Do you use a screwdriver to take off your running core and put it on your other beyblade? No, you use the end of the Dual Shooter to remove the Bit Protector. RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Pichuscute, the best you can make with those is DEMS with CWD Defense Ring. RE: Ask a question, get an answer! - Pich - Apr. 24, 2008 ok thx RE: Ask a question, get an answer! - Kei - Apr. 24, 2008 Bey Brad Wrote:Seldia Wrote:Is it possible to put an old bit-piece in? Or would that mean chopping up a bit-piece and is that legal? XD http://i61.photobucket.com/albums/h69/Kei-XvX/comparison002.jpg?t=1208999626 http://i61.photobucket.com/albums/h69/Kei-XvX/comparison001.jpg?t=1208999643 Clearly shows the differences. RE: Ask a question, get an answer! - Bey Brad - Apr. 24, 2008 Oh Black Dranzer MS~ |