Wave 5 SSt comes with 2 repeats not recolors V3 from Wave 1 and SR from Wave 4, as per EE barcodes on wholesale site , that is the same from previous releases
BEY SST GENESIS VALTRYEK V3
630509631575
BEY SST SPRYZEN REQUIEM S3
630509702961
BEY SST KHALZAR K3
630509714926
BEY SST BALKESH B3
630509714933
I've seen a few of the orange Genesis Valtryeks around still. It's one of the few beys I've seen for ages and just haven't seemed to go away, along with a batch of old Basic/Dual layers like Nepstrius Armed Zephyr and Yegdrion Ring Edge. The fact that those are still lining the shelves is pretty evident that people just don't want that recolor, or already got gV from a stadium set.
Speaking of stadium sets, I found the Ultimate Tournament Set and got it today, which meant I left behind a stock color Khalzar they had. No need to get it twice when there's one in the set here. It's a whole lot of bey for one purchase, and it has the incredibly tricky to get Hasbro Satomb.
Color-wise, it's an up-and-down ride. I like how Genesis Valtryek, Satomb, Khalzar, and Fafnir look. Genesis Valtryek pulls off the whole primary color scheme of red, blue, and yellow well, Satomb has gentle golden accents to it that make it stand out better in contrast with its primarily black body, Khalzar is slightly marbled like the original Beat Kukulcan and pops with those golden accents, and Fafnir looks like a piece of treasure when stationary. Lunior and Spryzen don't quite sit as well with me, since Lunior just doesn't look right in such a bright mustard yellow color scheme and Spryzen Requiem looks really awkward from the side, since the bottom half of the bey is the same gold as the original so it just turns from silver to gold halfway down the side and really only looks good from the top.
Performance-wise, I've seen a couple things that aren't quite typical, especially concerning Lunior and Spryzen Requiem. My Lunior has a defect that improves its burst resistance, as the dragon heads hit the outer ring halfway through and cause the layer to stick there unless a considerable amount of force is applied to move it past. Spryzen Requiem on the other hand has pitiful burst resistance for no reason I can discern. I even swapped the 0 disk out for the 0 from my original Spryzen Requiem to make sure it wasn't a mold variation in 0 (a variation within I had heard causing difficulties assembling the original due to increased thickness, which I also had issues with), and that improved it by an incredibly tiny amount.
I haven't gotten around to using the stadium yet, but it's a Hasbro stadium so it's probably not gonna be all that impressive. My mind's more preoccupied trying to figure out why this Spryzen Requiem is so weak compared to the stock version and curious to see if anyone else has had this issue.
(Sep. 28, 2018 8:01 PM)MagikHorse Wrote: [ -> ]My mind's more preoccupied trying to figure out why this Spryzen Requiem is so weak compared to the stock version and curious to see if anyone else has had this issue.
Yeah, it might be a universal thing. JoJo as well as @[bladekid] have experienced the same thing as well with their Spryzen Requiem S3s from the Ultimate Tournament Collection.
(Sep. 28, 2018 8:04 PM)kjrules17 Wrote: [ -> ] (Sep. 28, 2018 8:01 PM)MagikHorse Wrote: [ -> ]My mind's more preoccupied trying to figure out why this Spryzen Requiem is so weak compared to the stock version and curious to see if anyone else has had this issue.
Yeah, it might be a universal thing. JoJo as well as @[bladekid] have experienced the same thing as well with their Spryzen Requiem S3s from the Ultimate Tournament Collection.
This is a shame, since it makes this Spriggan Requiem one of the weakest beys in this set since it's so easy to burst. I mean, I guess it makes the Genesis Valtryek bursting Skryzen on the packaging accurate at least?
With how weak these slopes are, maybe it could pull off Balkesh's gimmick of "unbursting" in the good ol' classic Sr.0.Br combo? It's still not as good as the stock Spryzen Requiem that's basically impossible to burst, but it at least means the weakness perhaps isn't as bad as it might otherwise be.
(Sep. 28, 2018 4:53 AM)Jman jman Wrote: [ -> ] (Sep. 28, 2018 3:20 AM)Dutchems Wrote: [ -> ]Not sure if this is the right place for this but...
I totally found at my local Walmart in the U.S. three new hasbro beys, they were a recolor of valtryek v3, khalazar k3, and balkesh b3. So the next waves are definitely launching.
Cool what parts did V3 come with.
It came with reboot, and non meta disk and frame.
The colors were kinda bad imo, transparent red yellow and orange. I did not see the fourth bey so I still have no idea what it is, over the weekend I'll check my target and see if they have anything new as well.
(Sep. 28, 2018 8:58 PM)Dutchems Wrote: [ -> ] (Sep. 28, 2018 4:53 AM)Jman jman Wrote: [ -> ]Cool what parts did V3 come with.
It came with reboot, and non meta disk and frame.
The colors were kinda bad imo, transparent red yellow and orange. I did not see the fourth bey so I still have no idea what it is, over the weekend I'll check my target and see if they have anything new as well.
That's the first V3. From the first wave.
V3 and Sr are re-released
Need some improved information about Strike Valtryek V3 DR26L? (RipFire piece with vortex) TA11RC? (Remote controlled reboot) and Drain Fafnir F3 D28L? TS10RC?
So we are still forced to buy the set to get the standard Valkyrie colors... smart move, Hasbro, smart move.
It would've been nicer if Fafnir or Wyvron got rereleased, especially when Fafnir is more relevant in the show later on, but we can't have everything. I think SgV and Ul would've been nice.
(Sep. 29, 2018 4:31 AM)originalzankye Wrote: [ -> ][Image: wave5.jpg]Complete Wave 5 from Walmart
Was this in Canada? If so, whereabouts? I haven’t seen them around here yet.
Notice that v3 and s4 are pictured bursting satomb, so I believe just some extras.
Satomb bursting is wave 4 and 1 I believe.
(Sep. 30, 2018 12:57 AM)LegoBlader76 Wrote: [ -> ]Notice that v3 and s4 are pictured bursting satomb, so I believe just some extras.
We will have S4 in late 2019.
But I already know what you’re talking about.
Yeah, it is wave 1 valtryek.
Also I meant requiem which kind of counts as s4
I saw boom khalazer at my Walmart zankye and a genesis valtryek
Are Betromoth B4, Minoboros M4, and Anubion A4 just recolors?
(Sep. 30, 2018 10:51 PM)Flame-Byxis Wrote: [ -> ]Are Betromoth B4, Minoboros M4, and Anubion A4 just recolors?
I think so. That really sucks because anubion A4 is my favorite duel layer.
Are we sure that that orange Genesis Valtryek is part of this wave? I've had that exact bey since the first wave of Switchstrikes released. Is it a rerelease or something?
On the previous page I proved orange genesis is wave one. The bursting beyblade is satomb, not wyvron
(Oct. 01, 2018 4:10 AM)LegoBlader76 Wrote: [ -> ]On the previous page I proved orange genesis is wave one. The bursting beyblade is satomb, not wyvron
It doesn’t make sense for it to be wave 1 Switchstrike (despite that being the first release of it) as there are no other wave 1 Beys that have been found along with it, and we know that wave 5 includes B3, K3, SRS3 and V3, thanks to Entertainment Earth. While it is Satomb being bursted it’s probably because they already had the assets for the box finished and why fix something so minor?
wave 1 hasn't been spotted since like march IN America (still found online but not in stores) so its obviously wave 5 cuz Hasbro was too lazy to put treptune and noctemis in this wave
(Oct. 01, 2018 1:08 PM)bidinga Wrote: [ -> ]wave 1 hasn't been spotted since like march IN America (still found online but not in stores) so its obviously wave 5 cuz Hasbro was too lazy to put treptune and noctemis in this wave
How do you know it wasn't planned to have Spiral Treptune be released in Turbo to begin with?
“Minor Content Updates”
Welp, time to search.
OMG THERE’S SO MANY SUPER Z LAYERS
AND A CLONE OF FLUGEL, FLUGEL-S
AND THEY NAMED SCREW TRIDENT SPIRAL TREPTUNE T4. WOT?
If you’re looking at this Zankye, record right now about how you can get the most OP energy layers in the app right now.
Not sponsored by me.
‘wot?
Brutal Luinor isn’t equipped with the 13 disc, it’s just a layer-disc combo on its own.
And this is how you know every Turbo product is coming out soon. Just naming Guardian Kerbeus K4, “HAZARD KERBEUS”